Brick slip external wall insulation in Oban
If you live in Oban (PA34) and your walls are solid, system-built or simply cold, brick slip external wall insulation may be the most effective upgrade you can make without losing any room inside.
What is brick slip external wall insulation?
Brick slip external wall insulation is an EWI system finished with 10–20mm thick clay brick slips, bonded with adhesive onto a reinforced basecoat over the insulation and then pointed. Corner slips return around external corners so the finish reads as solid brickwork.
Brick slip EWI around Oban
Oban is in the PA34 postcode district. Surveys here are by appointment.
Argyll and Bute has some of the UK's more exposed locations for wind-driven rain, which shapes the render and detailing we specify.
Cost in Oban
Guide prices for brick slip external wall insulation in Oban run from about £185 to £265 per square metre installed, slips and pointing included; scaffolding priced per house, with VAT at 0% on homes until 31 March 2027.
Bays, gables, conservatory junctions and narrow side passages take longer than plain walls, so the survey prices your actual house rather than an average.
Key facts
- Bond
- Stretcher, Flemish-effect or to match
- Corners
- L-shaped corner slips
- Insulation underneath
- EPS or mineral wool, as certified
Why choose it
- Often an easier route through planning than render on brick streets
- Very durable, low-maintenance face
- Can mix with render on side and rear walls to manage cost
Can brick slips match my existing bricks?
Slips come in a wide range of colours and textures, and a close match is often possible. An exact match to weathered Victorian brick is hard; we bring samples to the survey and you see them against your wall in daylight before ordering.
More services in Oban
- EPS insulated render
- Mineral wool EWI
- Insulating lime render
- Detached house EWI
- Flats & low-rise blocks
- EWI for landlords
- EWI repairs
- EWI surveys
Rules that apply in Oban
- Funding
- Home Energy Scotland Grant and Loan offers up to £7,500 grant plus a £2,500 interest-free loan for solid wall insulation, with a rural and island uplift. You need a valid EPC recommending the measure, a TrustMark-registered installer, and a written offer before work starts. Warmer Homes Scotland helps eligible low-income households through its own installers. Our quotes are for privately funded work unless we confirm in writing that we can carry out a funded job. Grants guide
- VAT
- Installing insulation in a home is zero-rated for VAT until 31 March 2027, then 5%.
Checked October 2026. Rules change, so we confirm them for your address at survey.
Brick slip EWI in Oban: questions
Do I need planning permission for external wall insulation in Oban?
Changes to the external appearance of a house can need planning permission in Scotland, and flats, listed buildings and conservation areas always need checking with the council before EWI is ordered.
Is building control approval needed for brick slip external wall insulation in Oban?
An external wall insulation cladding system on a house normally needs a building warrant under the Building (Scotland) Regulations; only minor like-for-like repairs to an existing system are exempt. Section 6 of the technical handbooks sets the energy standards. We arrange it as part of the job.
Is VAT charged on brick slip external wall insulation in Oban?
Not on installing insulation in a home at the moment: that's zero-rated until 31 March 2027, after which the rate is due to be 5%. Work on commercial buildings is standard-rated.
Brick slip EWI | Brick slip EWI in Argyll and Bute | All services in Oban